SawStop tsa-sa48 Installation Manual page 10

INSTALLING WITH THE EXTENSION WING
Mounting the sliding crosscut table to your saw:
to the sliding table assembly. If the sliding table top is not locked, pull out the sliding table lock knob on the bottom of the table
assembly and rotate it 90 degrees, then release. Slowly slide the table top toward the Home Position. The Home Position is where
the front of the sliding table top is generally flush with the table bottom. The lock knob should engage the table top and lock it
against further movement. This will help prevent injury due to the sliding table top moving unexpectedly.
1. Turn the sliding table assembly upside down, slide the support leg T-bolts (109) into the sliding table T-slot
(see Fig. 1), then hand-tighten the legs clockwise to secure them in place.
Fig. 1
For the best
support, position
the legs near
the edges of the
sliding table, as
shown in Fig. 1.
2. For saws ONLY: if necessary, mount the switch box assembly as described in the installation
documentation for your saw, then continue to step 3.
3. For saws ONLY: remove the hardware from the ICS Wing Mounting Hardware pack (the
hardware from the ICS Table Mounting Hardware pack is not needed for this mounting configuration).
For saws ONLY: remove the cap screws, the flat washers and the lock nuts from the PCS/CNS Table or
Wing Mounting Hardware pack (the lock washers are not needed for this mounting configuration).
4. With the help of at least one other person to support the weight, turn the sliding table assembly over and
position it against the side of the extension wing.
5. Adjust the height of the sliding table to approximately match the wing by turning the foot pads on the bottom
of the leg assemblies.
6. Visually align the mounting holes in the side of the sliding table assembly with the holes in the side of the
wing and then mark the set of holes to be used. See Fig. 2 for
Fig. 2
PCS and CNS
saws have 4
mounting holes.
Fig. 3
ICS saws have 3
mounting holes.
8
SLIDING CROSSCUT TABLE INSTALLATION
Before continuing, make sure the sliding table top is locked
Flush
Flush
See the exploded
views on pages
22-23 for part
number labels.
saws, or Fig. 3 for saws.
Standard
Standard