SawStop tsa-sa48 Installation Manual page 18

INSTALLING WITHOUT THE EXTENSION WING
3. For saws ONLY: remove all the hardware from the ICS Table Mounting Hardware pack (the
hardware from the ICS Wing Mounting Hardware pack is not needed for this mounting configuration).
For saws ONLY: remove the cap screws, the lock washers and four of the flat washers from the
PCS/CNS Table or Wing Mounting Hardware pack (the remaining hardware is not needed for this mounting
configuration).
4. With the help of at least one other person to support the weight, turn the sliding table assembly over and
position it against the side of the saw table.
5. Adjust the height of the sliding table to approximately match the saw table by turning the foot pads on the
bottoms of the leg assemblies.
6. Visually align the mounting holes in the side of the sliding table assembly with the holes in the side of the saw
table and then mark the set of holes to be used. See Fig. 6 for
Fig. 6
PCS and CNS
saws have 4
mounting holes.
Fig. 7
ICS saws have 3
mounting holes.
7. Pull out the sliding table lock knob on the underside of the sliding table assembly and rotate it 90 degrees to
unlock the sliding table. Then slide the table top toward the front of the saw to expose two of the mounting
holes, as shown in Fig. 8.
Fig. 8
ICS Model Shown
without the
extension wing.
16
SLIDING CROSSCUT TABLE INSTALLATION
Flush
Flush
saws, or Fig. 7 for
saws.
Standard
Standard