SawStop tsa-sa48 Installation Manual page 16

INSTALLING WITHOUT THE EXTENSION WING
10. On saws without the left extension wing it is necessary to increase the slack in the motor power cord in
order to move the switch box to the new mounting position. The first step is to remove the motor power cord
from the strain relief on the rear of the saw (Fig.1). Remove the three screws that mount the strain relief to the
rear of the saw frame. Remove the cord connected to the motor and replace the strain relief. Make sure the
AC power cord remains captured by the strain relief.
11. If your saw is mounted on a Mobile Cart as shown in Fig. 2, simply route the motor power cord
underneath the upper frame of the Mobile Cart, then reconnect it with the motor power cord.
12. If your saw is mounted on the
of the stand. The center point of the hole should be located as shown in Fig. 3. SawStop recommends using
a 2" hole saw to form the hole in the rear panel. Finally, snap the supplied 2" grommet into the hole and feed
the cord from the motor through the grommet then reconnect it with the motor power cord.
Fig. 1
Fig. 2
Fig. 3
14
SLIDING CROSSCUT TABLE INSTALLATION
stand, it is necessary to create a 2" diameter hole in the rear panel