SawStop tsa-sa48 Installation Manual page 17

INSTALLING WITHOUT THE EXTENSION WING
Mounting the sliding crosscut table to your saw:
to the sliding table assembly. If the sliding table top is not locked, pull out the sliding table lock knob on the bottom of the table
assembly and rotate it 90 degrees, then release. Slowly slide the table top toward the Home Position. The Home Position is where
the front of the sliding table top is generally flush with the table bottom. The lock knob should engage the table top and lock it
against further movement. This will help prevent injury due to the sliding table top moving unexpectedly.
1. Turn the sliding table assembly upside down, slide the support leg T-bolts (109) into the sliding table T-slot
(see Fig. 4), then hand-tighten the legs clockwise to secure them in place.
Fig. 4
For the best
support, position
the legs near
the edges of the
sliding table, as
shown in Fig. 4.
2. For saws, skip to step 3. For
of the sliding table assembly using three M6x1.0x16 cap screws, three M6 washers and three M6 lock washers
from the Auxiliary Hardware Pack, as shown in Fig. 5. If you are mounting the Sliding Crosscut Table in the
standard configuration, align the holes in the bracket to the rear holes on the underside of the table (Fig. 5-A). If
you are mounting the Sliding Crosscut Table in the Flush Configuration, align the holes in the bracket to the front
holes on the underside of the table (Fig. 5-B).
Fig. 5
A
Standard Mounting Configuration
Before continuing, make sure the sliding table top is locked
See the exploded
views on pages
22-23 for part
number labels.
saws, attach the switch box mounting bracket (113) to the underside
B
Flush Mounting Configuration
SLIDING CROSSCUT TABLE INSTALLATION
15