SawStop tsa-sa48 Installation Manual page 21

INSTALLING WITHOUT THE EXTENSION WING
16. Use a 5mm allen wrench to slightly loosen the crosscut fence from the miter gauge as shown in Fig. 12. Do
not loosen the screws more than 1 ½ full turn. With the blade guard installed, raise the saw blade to the
highest elevation and tilt it to 45 degrees. Pivot the crosscut fence until it is parallel to the front edge of the
saw table. Slide the crosscut fence to the right until the right side of the crosscut fence is about 2 inches from
the left side of the blade guard. If you want to position the crosscut fence closer to the blade, be careful not
to run the crosscut fence into the blade guard or anti-kickback pawls during operation. Retighten the screws.
Fig. 12
17. Pivot the crosscut fence counter-clockwise until the left end of the long slot on the crosscut fence is off the
saw table. Remove the T-bolt (229) from the Crosscut Fence Lock Knob and insert the threaded shaft of the
T-bolt up through the slot on the fence as shown in Fig. 13. Pivot the fence clockwise and slide the T-bolt into
the T-slot in the left side of the sliding table top. Place the plastic washer (228) on the T-bolt threaded shaft and
then screw on the crosscut fence lock knob. Do not tighten the lock knob at this time.
Fig. 13
SLIDING CROSSCUT TABLE INSTALLATION
19