SawStop tsa-sa48 Installation Manual page 11

INSTALLING WITH THE EXTENSION WING
7. Pull out the sliding table lock knob on the underside of the sliding table assembly and rotate it 90 degrees to
unlock the sliding table. Then slide the table top toward the front of the saw to expose two of the mounting
holes, as shown in Fig. 4.
Fig. 4
ICS Model Shown
without the
extension wing.
8. For saws ONLY: with the mounting holes aligned, insert an M10x35 cap screw through a D-style washer,
then through one of the two exposed rear holes in the sliding table and extension wing, and then through a
second D-style washer and a lock nut. (See the exploded view on page 22-23 for illustration). Repeat this
process for the other exposed rear hole in the sliding table and extension wing. Only finger tighten the lock
nuts at this time. Make sure to position the flat edge of the D-style washers facing downward. Skip to step 10.
9. For saws ONLY: with the mounting holes aligned, insert an M8x35 cap screw through a flat washer,
then through one of the two exposed rear holes in the sliding table and extension wing, and then through a
second flat washer and a lock nut. (See the exploded view on page 22-23 for illustration). Repeat this process
for the other exposed rear hole in the sliding table and extension wing. Only finger tighten the lock nuts at this
time. Continue to step 10.
10. Slide the table top toward the back of the saw to expose the final mounting hole(s) and install the remaining
cap screw(s), washer(s), and lock nut(s). Only finger tighten the lock nuts at this time.
11. Slide the table top as necessary until only one cap screw is exposed at the front of the saw. Lay a straight
edge across the sliding table top so that it extends over the top of the table saw as close to the exposed cap
screw as possible. Make sure the sliding table top is parallel to the top of the wing and saw table and then
adjust the foot pad on the bottom of the front leg until the sliding table top is between 0.010" and 0.020"
higher than the table saw top. Tighten the exposed lock nut. Slide the table toward the front of the saw to
expose one cap screw at the back of the saw and repeat the process at this location. Recheck both ends of
the table (front and back) to make sure they are still correct. Then tighten the remaining lock nuts.
12. Pull out the sliding table lock knob on the underside of the sliding table assembly, rotate it 90 degrees then
release. Slide the table top toward the Home Position until it locks in place.
SLIDING CROSSCUT TABLE INSTALLATION
9