E2 Group - Pid Control Group - Powtran pi130 series User Manual

Chapter 5 Function parameter
Code Parameter name
ON OFF
ON OFF
ON OFF
ON OFF
ON ON
ON ON
ON ON
ON ON
When multi-speed is selected as frequency source, the 100.0% of function code E1.00
to E1.015 corresponds to maximum output frequency F0.08.
Multi-stage command is used for the function of multi-speed, also for PID setting
source to meet the need to switch between different setting values.

5-2-16.E2 Group - PID control group

Code Parameter name
PID setting source
E2.00
selection
When PID is selected as the frequency source, that is to choose 6 for F0.02, the group
function will be enabled. This parameter is used to select the process PID target value
setting channel.
The amount of process PID setting target is a relative value, the set 100% corresponds
to the 100% of feedback signal of the controlled system.
The system always operate in relative value (0 to 100.0%) .
Note: The multi-speed setting can be achieved by setting the parameters of E1 group.
Setting range
OFF OFF
OFF ON
ON OFF
ON ON
OFF OFF
OFF ON
ON OFF
ON ON
Keyboard setting (E2.01)
Analog channel AI1
setting
Analog channel AI2
setting
Panel potentiometer
setting
Remote communications
setting
Multi-speed setting
80
Factory default
command 7
Multi-speed
command 8
Multi-speed
command 9
Multi-speed
command 10
Multi-speed
command 11
Multi-speed
command 12
Multi-speed
command 13
Multi-speed
command 14
Multi-speed
command 15
Setting range
Change
E1.08
E1.09
E1.10
E1.11
E1.12
E1.13
E1.14
E1.15
Factory
Change
default
0
1
2
☆
0
3
4
5