Configuring Battery Settings; Configuring The Ups For An Extended Battery Module - IBM 11000 VA LCD 5U Installation And Maintenance Manual

To set the shutdown times for each load segment, complete the following steps:
1. From the main menu, press the down (
2. Press the down (
3. Press the down (
4. Press the down (
5. Press the OK button for 1 second to confirm.
6. Repeat step 3 to step 5 to set the other load segment, if applicable.

Configuring battery settings

Configure the UPS settings for an installed extended battery module, including
whether to run automatic battery tests.

Configuring the UPS for an extended battery module

If the UPS is not configured for the extended battery module, the UPS reports less
battery time remaining on the UPS front panel and to any remote software. You
might receive a shutdown warning prematurely.
Conversely, if the UPS is configured for the extended battery module but the
extended battery module is not connected to the UPS, the UPS reports more
battery time remaining, and it might shut down before it issues a warning.
Note: The default configuration is to issue an alarm when the batteries reach their
lowest limit, which enables an orderly shutdown.
For the maximum battery runtime when you are using power management software,
complete the following steps to configure the UPS for the extended battery module:
1. From the main menu, press the down (
2. Press the down (
3. Press the down (
4. Press the OK button for 1 second to confirm.
40
11000 VA UPS and 11000 VA EBM: Installation and Maintenance Guide
menu, and press the OK button.
) button to scroll to Automatic on Battery Shutdown, and
press the OK button.
) button to select the load segment that you want to set and
press the OK button.
) button to select the shutdown delay for the load segment.
menu, and press the OK button.
) button to scroll to External Battery Modules, and press
the OK button.
) button to select the battery number value that you want.
Configuration
UPS only (internal batteries)
UPS and one extended battery module
Note: Runtime is automatically adjusted according to present load levels and
whether an extended battery module is configured.
) button to scroll to the Configuration
) button to scroll to the Configuration
Setting
0 (default)
1