Chapter 4. Additional Uninterruptible Power Supply Features; Installing The Ups Manager Software; Rs-232 And Usb Communication Ports - IBM 11000 VA LCD 5U Installation And Maintenance Manual

Chapter 4. Additional uninterruptible power supply features

This chapter describes the following uninterruptible power supply (UPS) features:
v IBM UPS Manager software
v Communication ports (RS-232 and USB)
v Network management card
v Environmental monitoring probe

Installing the UPS Manager software

The UPS comes with the IBM UPS Manager software. The management software
provides up-to-date graphics of UPS power and system data and power flow. It also
gives you a complete record of critical power events, and it notifies you of important
UPS or power information. If there is a power outage and the UPS battery power
becomes low, the software can automatically shut down the system to protect the
data before the UPS shutdown occurs.
You can install the IBM UPS Manager software on a computer running a Microsoft
Windows or Linux operating system, as either a stand-alone application or part of a
network. To install the software, complete the following steps:
1. Connect a computer to either the RS-232 port or USB port on the UPS. See
2. Insert the IBM UPS Manager CD that comes with the UPS into the CD or DVD
3. Run the Software Wizard, which guides you through the installation process.
For more information about configuring and operating the software, see the online
help.
For more information about disabling control commands from the software, see the
Control commands from serial port setting in Table 8 on page 32.

RS-232 and USB communication ports

The UPS has an RS-232 port and a USB port that you can use for UPS monitoring,
control, and firmware updates. After communication is established between the UPS
and a computer, you can use the IBM UPS Manager software to exchange data
between the UPS and the computer. The software polls the UPS for detailed
information about the status of the power environment. If a power emergency
occurs, the software initiates the saving of all data and an orderly shutdown of the
devices that are connected to the UPS.
For the communication port locations, see "Rear view of the UPS" on page 9.
Note: Only one of the communication ports can be active at one time. The USB
port has priority over the RS-232 port.
© Copyright IBM Corp. 2011
"RS-232 and USB communication ports."
drive. If the Software Wizard install menu does not automatically open, see the
CD_ReadMe.txt file and follow the steps to manually open the wizard.
43