Web/Snmp Card Leds And Controls; Configuring The Web/Snmp Card Locally; Before You Begin - IBM UPS3000 LV Installation And Maintenance Manual

Web/SNMP card LEDs and controls

The following illustration shows the LEDs and controls on the Web/SNMP card.
100 Mb network LEDs (green)
Web/SNMP card
The Web/SNMP card LEDs are described in the following table.

Configuring the Web/SNMP card locally

Use the procedure in this section to access the Web/SNMP configuration utility
through a serial connector.

Before you begin

To use the configuration utility for the card, you need the following items:
v The DB9-to-RJ-45 cable that comes with the uninterruptible power supply
v A terminal with a serial communication port, or a computer with a terminal
10 Mb network LEDs (yellow)
Additional Ethernet Connectors
Table 3. Web/SNMP card LED descriptions
Status LED 10 Mb or 100 Mb LED
Flickering On / Flickering
On On
Off Off
Flashing Flashing (approximately
(approximately once once per second)
per second)
emulation program. Set the serial line to 9600 baud, no parity, 8 data bits, 1 stop
bit, and no flow control.
Uplink Ethernet connector
Power LED (green)
Status LED (yellow)
COM connector
Card function description
Normal operation with Ethernet traffic
Web/SNMP card error
Uninterruptible power supply power is low
(no power to the Web/SNMP card)
No connection to uninterruptible power
supply (alternate flashing as the
Web/SNMP card restarts)
Chapter 4. Using the Web/SNMP card
Off
DIP switch
On
1 2
Reset button
27