Gap Adjustment - Konica Minolta bizhub Pro 951 Additional Information

2.2 The Workflow of Both Sides Adjust
11
Press [OK].
Now the Scan Measurement Adjustment is completed.
% If fine tuning is needed, perform the Zoom/Image Shift Adjustment. See page 2-21 for details.
2.2.2

Gap Adjustment

Adjust the magnification ratio and printing position of the back side with reference to the printing position of
the front side. Output a chart to measure the measuring points on the back side to obtain the gap amount
between front and back sides in order to determine an adjustment value, and then enter the value to make
the adjustment.
NOTICE
Performing the Gap Adjustment may require readjustment of the Zoom/Image Shift Adjustment registered in
a paper profile.
NOTICE
Gap adjustment is a simple method to adjust only the magnification ratio and image position of the back side.
To adjust both front and back sides, perform the Chart Adjustment or Zoom/Image Shift Adjustment.
bizhub PRESS 1250/1250P/1052, bizhub PRO 951
2
2-11