Legacy Railsounds Sound System Operations; Installing The Battery - Lionel VISION 4-6-6-4 Challenger Owner's Manual

LEGACY RailSounds sound system operations

Installing the battery

A
lthough the LEGACY RailSounds sound system is powered through the track, we
recommend that you install a nine-volt alkaline battery in the tender to prevent the
sound system from shutting down during track power interruptions (for example, at a
switch or over a dirty section of track). Follow these steps and refer to Figure 4 page
11 as you install the battery.
If the RailSounds sound system turns off during interruptions in track power,
Note!
you may need to replace the battery. Use only alkaline batteries.
1. Remove the four body screw from the underside of the tender. Refer to Figure 4
page 11.
2. Lift the body off the frame.
3. Snap the battery harness onto the nine-volt alkaline battery's terminals.
4. Slide the battery into the battery holder.
5. Replace the body and secure it with the four body screws. Be careful to avoid
pinching wires.
10