Fan Control; Hold Setting; Maintenance - Crestron Prodigy System User Manual

®
Prodigy System
136 • Prodigy System: PMC2

Fan Control

A zone's fan can be set for automatic operation (Auto) or constant operation
(On). When set to AUTO, the fan will run when the system is cooling or
warming the controlled zone. When set to ON, the fan will always run. To set
the fan setting, press the FAN button to toggle between the Auto and On
settings. When the fan is operating in the Auto mode, "AUTO" will be
displayed.

Hold Setting

The Hold function allows you to maintain a temperature setpoint until the
Hold function is disabled. Any changes caused by a program change are
ignored while the Hold function is enabled.
Press HOLD (MODE + FAN) to maintain a temperature setting until HOLD
(MODE + FAN) is pressed again.

Maintenance

When the display shows "LO", the batteries inside the P-STATRF need to be
replaced. The P-TSTATRF requires two AA batteries. Refer to the following
diagram when replacing batteries.
•
Observe polarity when installing batteries.
•
When you change the batteries, replace all of them at the same time
with the same kind of battery.
•
With lithium and other battery types, do not open the batteries,
expose them to flame, or in any other way violate the manufacturer's
instructions.
•
Dispose of batteries according to local laws and regulations.
Crestron P-TSTATRF
System User Guide – DOC. 7007B