Combustion Engine; Gearbox; Storage; Extended Periods Of Inoperation (E.g. Winter Break) - Viking MT 5112 Z Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
Turn the socket (1) through approx. 90°
and it pull out.
Press the bulb (2) in the direction of the
socket (1) and hold. Carefully turn the
bulb (2) and remove.
● Install the bulb in reverse order.
Push the socket (1) into the headlamp
housing.
● Close the engine hood. (
0478 192 9807 C - EN

15.23 Combustion engine

Observe the operating and maintenance
instructions contained in the attached
engine instruction manual.
To achieve a long service life, it is always
particularly important to maintain a
sufficient level of oil and to change the
engine oil and air filter regularly.

15.24 Gearbox

For the user, the gearbox is maintenance-
free.
During the inspections of the machine by
the specialist dealer, the required
maintenance operations are performed on
the gearbox.

15.25 Storage

● Store the machine in a dry and dust-
free room out of reach of children and
unauthorised persons.
● Any machine faults must be remedied
prior to storage in order to maintain a
safe operating condition.
● Close the fuel cock. (
● Remove the ignition key and keep in a
place where no unauthorised persons,
especially children, can access it.
15.26 Extended periods of inoperation
(e.g. winter break)
● Clean the entire machine fully. In
15.4)
particular, also carefully clean all
external parts of the engine and
gearbox (especially the cooling ribs).
● Thoroughly lubricate/grease all moving
parts.
● Remove the fuel from the fuel tank and
carburettor (e.g. by running empty).
● Engage the parking brake. (
● Observe the information on
immobilisation in the engine instruction
manual.
● Perform an engine oil change (engine
instruction manual). (
● Remove the battery. (
● Store the fully charged battery safely in
a cool and dry room out of reach of
children.
15.27 Following storage for extended
periods (e.g. over winter)
● Check the battery voltage before
installing the battery. If the battery
voltage is lower than 11.5 V, fully
recharge the battery using a battery
charger before installation. (
● Install the battery. (
● Check the tyre pressures. (
15.7)
● Open the fuel cock. (
● Fill the fuel tank. (
● Check the engine oil filling level.
(
15.8)
8.14)
15.9)
15.19)
15.21)
15.19)
15.16)
15.7)
13.1)
57

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mt 5097 zMt 6127 zlMt 6112 zlMt 6112 cMt 5097 cMt 5097

Table of Contents