Level Sensor (Grass Catcher Box); Electronics; Self-Diagnosis When Starting - Viking MT 5112 Z Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
Disengaging the gearbox:
Pull the gearbox freewheel lever (1)
outwards to the stop and then raise.
Engaging the gearbox:
Guide the gearbox freewheel lever (1)
downwards and then press inwards to the
stop.

8.19 Level sensor (grass catcher box)

A continuous tone sounds if the grass
catcher box is full. This signals that the
grass catcher box needs to be emptied.
0478 192 9807 C - EN
Disengaging the mowing deck
stops the continuous tone.
The time for the filled grass catcher box
signal is adjusted by modifying the length
of the (grass catcher box) level sensor.
This allows you to adapt filling of the grass
catcher box to the characteristics of the
clippings.
A shorter sensor generally causes later
triggering of the signal (the grass catcher
box is filled to a greater extent, ideal for
very dry clippings).
The level sensor can be adjusted to 6
notched positions.
In delivery condition, the level sensor
(grass catcher box) is fully extended.
Adjusting the level sensor:
● Stop the engine. (
13.3)
● Engage the parking brake. (
● Remove the grass catcher box.
(
13.10)
Extend or shorten the level sensor by
moving the slide (1) of the (grass catcher
box) level sensor in the direction of the
arrows.
● Attach the grass catcher box. (

9. Electronics

In order to ensure safe operation, the ride-
on mower is equipped with electronics
which check all the safety devices before
each starting procedure and when the
mower is running.
The electronics in the models
MT 6112 C, MT 6112 ZL,
MT 6127 ZL also control the
display. The display on these
models therefore shows additional
information.

9.1 Self-diagnosis when starting

Before the engine is started, the
electronics perform self-diagnosis. This
8.14)
checks switches, wiring, etc. for correct
functioning.
Activating self-diagnosis:
● Sit on the driver's seat.
● Release the parking brake. (
● Turn the ignition key to the "ignition on"
position (
8.1) – do not press any
buttons and switches or actuate any
pedals.
Self-diagnosis without faults:
A short beep sounds – the electronics are
activated and the ride-on mower is ready
to start.
MT 6112 C, MT 6112 ZL, MT 6127 ZL:
All symbols are shown on the display for
2 seconds. The operating hours can be
read off for 5 seconds.
● Start the engine. (
13.10)
8.14)
13.2)
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mt 5097 zMt 6127 zlMt 6112 zlMt 6112 cMt 5097 cMt 5097

Table of Contents