Konica Minolta bizhub PRESS C1100 Quick Manual page 61

N
Press [Exit Print Mode].
O
Measure a misalignment between the
marks of [1] to [4] printed on the
[back] side of the output chart and the
marks on the [front] side.
- The figure shows an example to measure [1].
The scale resolution is 0.5 mm.
-
In this figure, the black mark
the front side and the blue mark
the back side.
-
Measure a misalignment between printing
positions in the horizontal direction (X axis)
and vertical direction (Y axis).
-
The measurement value can be entered in
units of up to 0.1 mm.
-
For example, as shown in the figure, if
point [1] is misaligned 2.0 mm in the plus side
of the X direction and 1.5 mm in the minus
side of the Y direction compared with the
front side, press [2] - [0] - [+/–] in the X
direction to enter "–2.0" as the adjustment
value, and press [1] - [5] in the Y direction to
enter "+1.5" as the adjustment value. Then,
at point [1], the blue line on the back side will
be moved 2.0 mm toward the minus side of
the X direction and 1.5 mm toward the plus
side of the Y direction.
-
Write down the measured values so that you
do not forget them.
indicates
indicates
at
bizhub PRESS C1100/C1085
5-11
5