Backrest 2; Push Mode 2 - Meyra SPRINT GT 2.593 Operating Manual

Adjustment of seat width
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Push the armrest outwards/inwards.
– This is carried out by loosening the
relevant adjusting screw (A, Fig. 28)
on the clamping guide.
! Attention:
Only move the armrest outwards as
far as the guiding mark on the tube!
– Tighten adjusting screw (A, Fig. 28)
again. – Ensure that it is secured.
BACKREST
The backrest can be inclined and re-
moved.
Removing the back
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Screw out the securing screws until
the backrest is released (A, Fig. 30).
– Remove the backrest in an upward
direction (Fig. 29).
Fitting the backrest
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Insert the backrest into the mounting
tubes (up to the end stop).
– Screw in the securing screws (A, Fig.
31).
Adjusting the backrest angle
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Slacken the screw connection (B, Fig.
30).
– Remove the adjustment screw (C,
Fig. 30).
– Move backrest to the desired angle.
– Screw in the adjusting screw (C) at
the new position
– Tighten the screw connection (B, Fig.
30).
PUSH MODE
The SPRINT GT can also be switched to
push mode.
The electronic wheelchair has a consid-
erably higher weight than conventional
wheelchairs (motor, batteries). This
means that higher pushing and steering
force are necessary.
Attention:
!
Only push the wheelchair on level
surfaces.
The electromagnetic brake is switched
from drive to push mode by way of the
brake release lever on the side of the
wheelchair!
The brake release lever on the side of
the wheelchair is used to switch the elec-
tromagnetic brake from drive mode to
push mode! – Controlled braking is not
possible!
Push mode
– Switch off the wheelchair before
changing to the push mode. –Do this
by pressing the ON/OFF key [34]
on the control box.
+
Remark:
First pull the knob on the brake
release lever, then push the brake
release lever backwards. (Fig. 4).
Drive mode
Push the brake release lever forward,
(Fig. 3).
21