Armrests 2; Seat Unit - Meyra SPRINT GT 2.593 Operating Manual

ARMRESTS
The armrests (3) generally have padded
armrests. They are lockable and detach-
able, as well as adjustable in height,
(Fig. 24).
Benefits:
– Adjusting screws prevent the arm-
rests from inadvertently sliding out
– Mudguard
– Wind protection.
– Lateral support for body
– Relaxation of the shoulder muscles
due to padded height adjustable
armrests.
Attention:
!
Armrests are movable and remova-
ble parts which are not suitable for
lifting or carrying the wheelchair (see
warning note on the armrests).
Removing the armrests
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Remove the armrest in an upwards
direction (Fig. 25). – This is carried
out by loosening the relevant adjust-
ing screw (B, Fig. 6) on the clamping
guide.
+
Remark:
The cable must be withdrawn care-
fully in the case of an armrest with a
control box!
Attention:
!
Removed armrests must be carefully
replaced before the wheelchair is
used again!
• Never use the wheelchair unless the
armrests are mounted.
20
Mounting the armrests
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Insert the armrests into their guides
(up to the end stop) and then tighten
the adjusting screws (B, Fig. 6).
Attention:
!
Danger of crushing!
Height adjustment of the
armrests
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Loosen adjustment screw (B, Fig. 6).
– Position the armrest at the required
height (but no higher than the guiding
mark).
! Attention:
Observe the minimum insertion
depth of 5 cm (marking)!
– Danger of crushing!
– Tighten the adjusting screw (B, Fig. 6)

SEAT UNIT

The seat unit can be swivelled down for
maintenance and repair work (Fig. 27).
Swivelling down the seat unit
– Switch off the wheelchair and move
the brake release lever to the "drive"
position. – This prevents the wheel-
chair from rolling away accidentally.
– Remove the legrests if necessary.
– Pull the locking knob (A, Fig. 26) and
swivel down the seat unit (Fig. 27).
Attention:
!
When swivelling down the seat unit,
the wheelchair must stand on a level
surface on which the push handle will
also rest (Fig. 27).
– Grip at the front edge of the seat
plate and/or the U-shaped bar to
swivel down the seat unit.
Swivelling up the seat unit
– Slowly swivel the seat unit forwards.
– Hold the seat when doing this!
! Attention:
Do not hold in the middle of the U-
shaped bar! – Danger of crushing!
– Press the seat down to the end stop.
– The locking mechanism must audib-
ly click into place.