Mounting The Loop Handle; Adjusting The Throttle Cable; Fitting The Carrying Ring - Stihl FS 100 RX Instruction Manual

English

Mounting the Loop Handle

Fit the loop handle (1) at a
N
distance (A) of approx. 20 cm
forward of the control handle (2)
Orient the loop handle
N
Tighten down the bolts
N
The sleeve (3) must be located between
the loop handle and the control handle.
16

Adjusting the Throttle Cable

A properly adjusted throttle cable is the
precondition for correct operation in the
starting throttle, idle and full throttle
positions.
Adjust the throttle cable only when the
machine is completely and properly
assembled.
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
1
2
Press down the trigger lockout (1)
N
and squeeze the throttle trigger (2)
(full throttle position) – this sets the
throttle cable correctly.

Fitting the Carrying Ring

The carrying ring comes standard with
the machine or is available as a special
accessory.
1
1
2
For position of carrying ring see "Main
Parts".
Place the clamp (1) against the
N
drive tube with the tapped hole on
the left (viewed from engine).
Squeeze the two ends of the clamp
N
together and hold in that position.
Insert the M6x14 screw (2).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
FS 100 RX