Mounting The Loop Handle - Stihl FS 250 Instruction Manual

Mounting the Control Handle
4
3
1
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert the screw (1) and tighten it
N
down firmly.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
FS 250, FS 250 R
2
6
5
6
Push the throttle cable (1) into the
N
retainers (2).
Adjusting the Throttle Cable
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
2
1
1
2

Mounting the Loop Handle

Mounting Loop Handle with Barrier Bar
2
1
Fit the square nuts (1) in the barrier
N
bar (2); the holes must line up.
English
1
15