Mounting The Loop Handle; Mounting The Deflector; Mounting The Cutting Attachment - Stihl FSE 60 Instruction Manual

6 Mounting the Loop Handle

6 Mounting the Loop Handle
6.1 Mounting the Loop Handle
1
4
5
3
40 mm
► Fit the loop handle (1) on the drive tube at a
distance A of about 30 cm from the control
handle (2).
► Insert the hex nut (3) in the loop handle (1).
► Squeeze the ends of the clamp together, fit
the M6x40 screw (4) with washer (5) from the
other side and tighten down firmly.
6.2 Adjusting Loop Handle to Most
Comfortable Position
► Loosen the screw (4).
► Move the loop handle (1) along the drive tube
to the required position – tighten down the
screw (4) firmly.
7

Mounting the Deflector

2
► Push the deflector (1) over the clamp (2) as far
as stop.
0458-282-9621-B
A
2
1
4
► Fit the locknut (3) in the hex recess on the
deflector.
► Make sure the holes line up.
► Insert the M6x30 screw (4) and tighten it down
firmly.
8 Mounting the Cutting
Attachment
8.1 Placing Power Tool on the
Ground
► Switch off the power tool.
► Lay your trimmer on its back with the loop
handle facing down and the output shaft facing
up.
8.2 Fitting Mowing Head without
Screw Mounting
Keep the supplement sheet for the mowing head
in a safe place!
English
3
27