Mounting The Cutting Attachment - Stihl FS 100 RX Instruction Manual

Mounting the Cutting
Attachment
Laying down the machine
Switch off the engine
N
Lay down the machine so that the
N
mount for the cutting attachment
faces upward
Blocking the shaft
1
3
2
To mount and remove the cutting
attachments, the shaft (1) must be
blocked with the locking pin (2) or Allen
wrench (2). The parts are included in the
scope of delivery and are available as
special accessories.
FS 100 RX
Push the locking pin (2) or Allen
N
wrench (2) as far as it will go into the
hole (3) in the gear – press gently
Turn the shaft, nut or cutting
N
attachment until the locking pin
engages and the shaft is blocked
Mounting the STIHL PolyCut 20-3
Keep the supplement sheet for the
mowing head in a safe place.
2
WARNING
Only mount the mowing head with
doubled stepped support as shown
above.
Mounting the mowing head with a
threaded connection
Keep the supplement sheet for the
mowing head in a safe place.
1
Turn the mowing head
N
counterclockwise as far as possible
onto the shaft (1)
Block the shaft
N
Tighten the mowing head
N
NOTICE
Remove the tool again used to block the
shaft.
Removing the mowing head.
Block the shaft
N
Rotate the mowing head clockwise
N
English
17