The Fax Does Not Work Properly; Transmission Is Poor - Konica Minolta Di3510f User Manual

9
9.1

The Fax Does not Work Properly

Transmission is poor

Fax Status
Original cannot be
scanned.
The original is fed
crooked.
When the image
received by the
destination is unclear.
The image received by
the destination is blank.
Automatic transmission
is not possible.
When the transmission
stamp is faint.
(optional)
9-2
Apparent Cause
Is the original too thick?
Is the original too thin or too small?
Is the glass dirty?
Does the width of the original match
the setting guide?
Is the original set correctly?
Is the glass dirty?
Is the writing on the original faint?
Is there any problem with the
connection to the receiving fax?
Is the surface of the document to be
transmitted set face-down? (When
using the paper feed tray)
Is the fax number incorrect?
Is the number telephone-dedicated?
Is the reason on the destination side?
(Paper empty, automatic reception
disabled, power is OFF, etc.)
Is the memory remaining low?
Is the stamp ink (Spare TX Marker
STAMP 2) close to the end of its
operational life?
9.1 The Fax Does not Work Properly
Countermeasures
Place the original on the glass and
then transmit the document.
Place the original on the glass and
then transmit the document.
Wipe the glass with a soft cloth.
Match the width of the original to the
setting guide.
Set the original correctly.
Wipe the glass with a soft cloth.
Set the scan density.
Check by making a copy with the
product. If the image of the copy is
clear, transmit again.
Set the surface of the document to be
transmitted set face-upward, and
transmit again.
Check the fax number.
Check the fax number.
Check the destination.
After the document stored in memory
has been sent and the memory
remaining increased, send again.
Replace the stamp ink (Spare TX
Marker STAMP 2).
Di2510f/Di3010f/Di3510f