Rotor Assembly - Dynacraft BMX Owner's Manual

9. ROTOR ASSEMBLY

C
To assemble the brakes on a gyro equipped bike, start by inserting the two loose ends of the rear brake
cable (which comes from the right side brake lever) through the handlebar and threading them into the upper
detangler plate. The longer side goes on the left side of the bike, while the shorter one goes on the right side
of the bike (the same side as the rear brake lever). Thread the barrel adjusters into the detangler plate until
they are snug.
Take the actual cable ends, and pull them down into the lower plate slots, lifting the lower detangler plate to
help if necessary.
CAUTION:
While you're working on the gyro brake cables, they may pop out of the black
cable splitter or brake lever. Try to keep everything in place. If they fall out, just put them back in.
21
Barrel
adjusters
Detangler
plate
Lower
plate
Cable end