Dynacraft BMX Owner's Manual page 23

On a gyro equipped bike you need to
C
hook up the left-side brake lever cable,
which controls the front brake. Begin
by loosening the anchor nut on the
front brake. Take the loose cable on
the opposite end (the end which goes
into the brake lever on the handlebar),
and slot the nipple end into place
underneath the brake lever. (See Figure
2.) Rotate the barrel adjuster so the
slots are aligned, then bring the cable
across and up into the lever. Rotate
the barrel adjuster to secure it. Make
sure the slot is no longer lined up. (See
Figure 3.)
On the front brake caliper, squeeze the
brake arms together against the rim of
the wheel. While still holding the brake
arms, pull the cable firmly through the
cable anchor nut and tighten the nut
securely. (See Figure 4.)
WARNING:
Ensure the Gyro
Handlebar/Stem/Wheel system can rotate
360 degrees without binding any cables and
that the gyro mechanism works smoothly.
1
Brake Lever Nipple Ferrule
Locking
nut
Grip Handlebar
3
2
Cable
adjuster
barrel
4
22