D Bicycle Adjustments; Seat Adjustment - Dynacraft BMX Owner's Manual

BICYCLE ADJUSTMENTS
D

SEAT ADJUSTMENT

You can adjust the up and down tilt
of your seat as well as the forward
and back position by loosening the
seatpost hardware at the bottom of
your seat. (See Figure 1.) Be careful not
to loosen them all the way so that the
nut comes off on either side. Loosen
enough to make the adjustments, and
re-tighten the nuts.
To raise or lower your seat, use the
quick release lever (see Figure 2), an
adjustable or Allen wrench on the seat
clamp – (see Figure 3) depending on
the style of clamp your bike comes
with. Make sure the minimum insertion
marks on the seatpost are completely
covered. (See Figure 4.) Close the
quick release lever, or tighten the nut
on your seat clamp until it is secure,
and the seat will not move side-to-side
or sink with the rider seated.
WARNING
The seatpost must be
inserted far enough so that the minimum
insertion marks cannot be seen.
28
1
Closed
Open
Seatpost
3
Seat tube
Minimum insertion marks are
located on the seatpost
2
4