Front Wheel - Dynacraft BMX Owner's Manual

6. FRONT WHEEL

WARNING:
It is very important to check the front wheel connection to the
bicycle. Failure to properly tighten may cause the front wheel to dislodge, causing
serious injury or death.
Check the side of your tire to see if there is an arrow indicating direction. If an
arrow is present, it should point forward. If there is no arrow, the wheel can be
installed in either direction.
Loosen or remove the axle nuts and washers from the front wheel. Place the
front wheel into the fork, making sure it is completely seated and even. Place
or slide the wheel retaining washers on the axle (see Figure 1) , ensuring that
the tabs on the washers face the fork
and fit into the small holes on the fork.
(See Figure 2.) Tighten the axle nuts
with an adjustable or 15mm open ended
wrench.
WARNING:
Put the wheel in the
center of the fork and tighten both nuts.
WARNING:
Failure to obey these
steps can allow the front wheel to loosen or
dislodge while riding. This can cause injury
or death to the rider or to others.
1 2
C
18