Fault Code 35 - Yamaha FZ8NA Service Manual

Fault code No.
Item
Fail-safe system
Diagnostic code No.
Actuation
Procedure
Item/components and
probable cause
2 Connection of wire harness
ECU coupler
Check the connection of the
coupler is secure.
Remove the coupler, and
check each pin (for bending,
wear, or locking).
3 Connection of ignition system
sub-wire harness coupler
Check the connection of the
coupler is secure.
Remove the coupler, and
check each pin (for bending,
wear, or locking).
4 Continuity of wire harness
5 Ignition coil installation status
Check the mounting section
for a loose or pinched mount-
ing.
35
Cylinder-#3 ignition coil: open or short circuit detected in the pri-
mary lead of the cylinder-#3 ignition coil.
Able to start engine (depending on the number of faulty cylinders)
Able to drive vehicle (depending on the number of faulty cylinders)
d:32
Actuates the cylinder-#3 ignition coil five times at one-second inter-
vals.
Illuminates the engine trouble warning light.
Check that a spark is generated five times.
• Connect an ignition checker.
Check or maintenance job
Poor connection → Connect it
securely or replace the wire
harness.
Poor connection → Connect it
securely, or replace the wire
harness.
Open or short circuit →
Replace the wire harness.
Orange/green–Orange/green
Make sure that the mounting
position is correct.
FUEL INJECTION SYSTEM
8-80
Sensor inspection proce-
dure
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Start and idle the engine for
approximately 5 seconds.
Then, check the fault code
indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.