Yamaha FZ8NA Service Manual page 154

4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter cartridge is also to be
replaced, perform the following procedure.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the oil filter cartridge "1" with an oil
filter wrench "2".
Oil filter wrench
90890-01426
YU-38411
b. Lubricate the O-ring "3" of the new oil filter
cartridge with a thin coat of engine oil.
ECA13390
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter car-
tridge.
PERIODIC MAINTENANCE
c. Tighten the new oil filter cartridge to speci-
fication with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Install:
• Engine oil drain bolt
(along with the gasket
Engine oil drain bolt
43 Nm (4.3 m·kgf, 31 ft·lbf)
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
Total amount
3.80 L (4.02 US qt, 3.34 Imp.qt)
Without
replacement
2.90 L (3.07 US qt, 2.55 Imp.qt)
With oil filter cartridge replace-
ment
3.10 L (3.28 US qt, 2.73 Imp.qt)
8. Install:
• Engine oil filler cap
(along with the O-ring
9. Start the engine, warm it up for several
minutes, and then turn it off.
10. Check:
• Engine
(for engine oil leaks)
11. Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-24.
3-25
3
)
New
oil filter cartridge
New )