Yamaha FZ8NA Service Manual page 111

1. Atmospheric pressure sensor
2. Battery positive lead
3. Radiator fan motor relay
4. Fuse box 1
5. Lean angle sensor
6. Right turn signal light lead
7. License plate light lead
8. Turn signal/hazard relay
9. Seat lock cable
10.Headlight relay
11.Tail/brake light coupler
12.ABS test coupler
13.ABS test coupler connector
14.Left turn signal light lead
15.Starting circuit cut-off relay
16.Starter relay
17.ABS fuse
18.Battery box
19.Starter motor lead
20.Rear frame
21.Wire harness
22.Battery negative lead
23.Battery
24.Lean angle sensor lead
25.Mudguard
26.Rear fender
27.Tail/brake light lead
28.Tool band
29.Tool
30.ABS test coupler lead
A. Route the battery positive lead under each
relay.
B. For the radiator fan motor relay, connect
the coupler and then put the rubber cover
of the wire harness.
C. Route the fuse box 1 lead under the radia-
tor fan motor relay.
D. Route the battery positive lead under the
fuse box 1 lead.
E. Connect the connectors of the green tube
and lead.
F. Connect the connectors of the gray tube
and blue lead.
G. Route the license plate light lead and right
turn signal light lead under the turn signal/
hazard relay.
H. Route the license plate light lead and rear
right turn signal light lead between the ribs
of the battery box.
I. Route the license plate light lead and rear
right turn signal light lead under the rubber
cover.
J. Route the tail/brake light lead and rear left
turn signal light lead under the rubber
cover.
K. The ABS check coupler should not cover
the top of the bolt.
L. Route the tail/brake light lead and rear left
turn signal light lead between the ribs of
the battery box.
M. Route the tail/brake light lead coupler
under the headlight relay.
N. Slide the rubber cover over the ABS check
coupler, double-up by folding the coupler,
and then route the coupler under the tool
and along the left wall of the battery box.
O. Connect the connectors of the red tube
and brown lead.
P. Order insignificant-starter motor lead and
seatlock cable.
Q. Push the wire harness firmly to the end.
R. Route the lean angle sensor lead on the
top of the vehicle.
S. Order insignificant-wire harness and left
turn signal light lead.
T. Route the tail/brake light lead and rear left
turn signal light lead between the ribs of
the battery box.
U. Order insignificant-tail/brake light lead and
rear left turn signal light lead.
V. Route the ABS check coupler lead under
the tool and then fix it with the tool band.
2-62
CABLE ROUTING