Yamaha FZ8NA Service Manual page 319

9. Install:
• Dowel pins
• Clutch cover gasket
• Clutch cover "1"
Clutch cover bolt
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
TIP
• Apply engine oil onto the bearing.
• Apply locking agent (LOCTITE®) to the
threads of only the clutch cover bolts "a"
shown in the illustration.
• Tighten the clutch cover bolts in stages and
in a crisscross pattern.
10. Install:
• Pull lever
TIP
• Install the pull lever with the "O" mark facing
toward lower side.
• When installing the pull lever, push the pull
lever and check that the punch mark "a" on
the pull lever aligns with the mark "b" on the
clutch cover. Make sure that the pull rod
teeth and pull lever shaft pinion gear are
engaged.
New
5-54
11. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-13.
Clutch cable free play
10.0–15.0 mm (0.39–0.59 in)
CLUTCH