Cac Service Configuration Example - HP a-msr Configuration Manual

Figure 25 Network diagram for WMM basic configuration
IP network
Configuration procedure
# Configure interface WLAN-BSS 1 to use the 802.1 1e priority of the received packets for priority mapping.
<Sysname> system-view
[Sysname] interface wlan-bss 1
[Sysname-WLAN-BSS1] qos trust dot11e
[Sysname-WLAN-BSS1] quit
# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority mapping.
[Sysname] interface Ethernet 1/0
[Sysname-Ethernet1/0] qos trust dot1p
[Sysname-Ethernet1/0] quit
# Create a clear-type WLAN service template, configure its SSID as market, configure its authentication
method as Open System, and then enable the WLAN service template.
[Sysname] wlan service-template 1 clear
[Sysname-wlan-st-1] ssid market
[Sysname-wlan-st-1] authentication-method open-system
[Sysname-wlan-st-1] service-template enable
# Configure the radio type as 802.1 1g for radio interface WLAN-Radio 2/0, and map service template 1 to
interface WLAN-BSS1 on the radio interface.
[Sysname] interface wlan-radio 2/0
[Sysname-WLAN-Radio2/0] radio-type dot11g
[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
# Enable WMM on radio interface WLAN-Radio 2/0.
[Sysname-WLAN-Radio2/0] wmm enable
[Sysname-WLAN-Radio2/0] quit
After WMM is enabled, you can use the display wlan wmm radio command to view WMM-related
information.

CAC service configuration example

Network requirements
As shown in
AC-VO and AC-VI queues of the fat AP. Use a user-based admission policy to allow up to 10 users to access,
so that enough bandwidth can be guaranteed for the clients using high-priority queues (AC-VO and AC-VI
queues).
L2 switch
Figure 26, a fat AP is connected to an Ethernet and has WMM enabled. Enable CAC for the
FAT AP
Client
60