Svp Service Configuration Example - HP a-msr Configuration Manual

requesting for high-priority AC queues on the AP is smaller than or equal to the maximum number of
high-priority AC clients (10 in this example), the request is accepted. Otherwise, the request is denied.

SVP service configuration example

Network requirements
As shown in Figure
packets are assigned to the AC-VO queue. To guarantee the highest priority for the AC-VO queue, ECWmin
and ECWmax are set to 0 for the AC-VO queue.
Figure 27 SVP service configuration
L2 Switch
FAT AP
Client
Configuration procedure
# Configure interface WLAN-BSS 1 to use the 802.1 1e priority of received packets for priority mapping.
<Sysname> system-view
[Sysname] interface wlan-bss 1
[Sysname-WLAN-BSS1] qos trust dot11e
[Sysname-WLAN-BSS1] quit
# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority mapping.
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] qos trust dot1p
[Sysname-Ethernet1/0] quit
# Create a clear-type WLAN service template, configure its SSID as market, configure its authentication
method as Open System, and then enable the WLAN service template.
[Sysname] wlan service-template 1 clear
[Sysname-wlan-st-1] ssid market
[Sysname-wlan-st-1] authentication-method open-system
[Sysname-wlan-st-1] service-template enable
# Configure the radio interface WLAN Radio 2/0.
[Sysname] interface wlan-radio 2/0
[Sysname-WLAN-Radio2/0] radio-type dot11g
[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
[Sysname-WLAN-Radio2/0] wmm enable
[Sysname-WLAN-Radio2/0] wmm svp map-ac ac-vo
27, the fat AP is connected to the Ethernet and has WMM enabled. On the fat AP, SVP
IP network
62