Configuring The Radio Of The Ap - HP a-msr Configuration Manual

To do...
2. Enter radio interface view.
3. Specify a radio type for the
radio.
4. Bind a service template to a
WLAN-ESS interface for the
radio.
5. Specify a working channel for
the radio.
6. Specify the maximum radio
power.
7. Specify the type of preamble.

Configuring the radio of the AP

To configure the radio of the AP:
To do...
1. Enter system view.
2. Enter radio view.
3. Set the interval for sending
beacon frames.
4. Set the DTIM counter for
beacon frames.
5. Set the fragment threshold.
Use the command...
interface wlan-radio
interface-number
radio-type [ type { dot11b | dot11g |
dot11gn } ]
service-template
service-template-number interface
wlan-bss interface-number
channel { channel-number | auto }
max-power radio-power
preamble { long | short }
Use the command...
system-view
interface wlan-radio radio-number
beacon-interval interval
dtim counter
fragment-threshold size
16
Remarks
—
Required.
Required.
Optional.
By default, auto mode is enabled.
The working channel of a radio
varies with country codes and
radio types. The channel list
depends on your device model.
Optional.
By default, the maximum radio
power varies with country codes,
channels, AP models, radio types
and antenna types. If 802.11n is
adopted, the maximum radio
power also depends on the
bandwidth mode.
Optional.
By default, the short preamble is
supported.
This command does not apply to
802.11a radios.
Remarks
—
Required.
Optional.
By default, the beacon interval is
100 TUs.
Optional.
By default, the DTIM counter is 1.
Optional.
By default, the fragment threshold
is 2346 bytes and must be an
even number.