Table of Contents
Advertisement
Figure 26 Network diagram for CAC service configuration
L2 Switch
IP network
FAT AP
Client
Configuration procedure
# Configure interface WLAN-BSS 1 to use the 802.1 1e priority of received packets for priority mapping.
<Sysname> system-view
[Sysname] interface wlan-bss 1
[Sysname-WLAN-BSS1] qos trust dot11e
[Sysname-WLAN-BSS1] quit
# Configure interface Ethernet 1/0 to use the 802.1p priority of received packets for priority mapping.
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] qos trust dot1p
[Sysname-Ethernet1/0] quit
# Create a clear-type WLAN service template, configure its SSID as market, configure its authentication
method as Open System, and then enable the WLAN service template.
[Sysname] wlan service-template 1 clear
[Sysname-wlan-st-1] ssid market
[Sysname-wlan-st-1] authentication-method open-system
[Sysname-wlan-st-1] service-template enable
# Configure the radio type as 802.1 1g for radio interface WLAN-Radio 2/0, and map service template 1 to
interface WLAN-BSS1 on the radio interface.
[Sysname] interface wlan-radio 2/0
[Sysname-WLAN-Radio2/02] radio-type dot11g
[Sysname-WLAN-Radio2/0] service-template 1 interface wlan-bss 1
# Configure radio interface WLAN-radio 2/0 to allow up to ten users to use high-priority AC queues
(including AC-VO and AC-VI queues).
[Sysname-WLAN-Radio2/0] wmm edca client ac-vo cac
[Sysname-WLAN-Radio2/0] wmm edca client ac-vi cac
[Sysname-WLAN-Radio2/0] wmm cac policy users 10
[Sysname-WLAN-Radio2/0] wmm enable
[Sysname-WLAN-Radio2/0] quit
If a client wants to use a high-priority AC queue (AC-VO or AC-VI queue), it must send a request to the AP.
If the number of clients using high-priority AC queues (including AC-VO and AC-VI queues) plus the clients
61
Advertisement
Table of Contents
