Wet Level; Dry/Wet; Settings Menu; Parameter - Elektron Analog heat Quick Manual

5.7 WET LEVEL

Sets the level of the signal coming from the effect. It is applied before the DRY/WET mix. It is used to
match the level of the dry signal for easy mixing of the two.

5.8 DRY/WET

Sets the mix between the clean signal and the signal that is affected by the effect.

5.9 SETTINGS MENU

Press [SETTINGS] to access the SETTINGS menu.
Scroll through the list of settings by using the PRESET/DATA knob. Open a highlighted menu by press-
ing the PRESET/DATA knob or [YES]. To change the settings in the menus, first press, and then turn
the PRESET/DATA knob.
5.10 PARAMETER PAGES
Access the parameter pages by pressing the corresponding key [AMP], [FILTER/EQ], [ENV], and
[LFO]. There are two pages associated with each key (AMP has only one page). You can access the
secondary pages by pressing the [PARAMETER] key a second time.

5.11 PARAMETER EDITING

The four DATA ENTRY knobs are used to change the parameter values that are shown on the LCD
screen. (Some parameters also have dedicated knobs on the panel.) The physical location of the
knobs on the front panel correspond to the layout of the parameters on the screen.
• The parameters will be adjusted in larger increments if you press down the DATA ENTRY knob
while turning it. This makes it much quicker to sweep through a whole parameter range.
• Press [SETTINGS] + turn DATA ENTRY knob to quantize the parameter value to integers.
• Press DATA ENTRY knob + [NO] to reset the parameter to the default value.
Press [PARAMETER] key + [NO] to reset the selected parameter group to default values.
•
• Use the [NO] key to exit an active menu, back to a higher level menu and to negate.
19