Table of Contents
Advertisement
4. [ENV] key accesses the ENV parameter pages where you adjust the settings for the envelope
generator/envelope follower. Press twice to access the second page.
5. [LFO] key accesses the LFO parameter pages where you set all things related to the Low
Frequency Oscillator. Press twice to access the second page.
6. LCD screen.
7. PRESET/DATA Used for preset management and data entry.
8. [YES] key is used for entering sub-menus, selecting and confirming.
9. [NO] key is used for exiting the current menu, backing to a higher level menu and negating.
10. DATA ENTRY knobs. Used to set parameter values. For more information, please see "5.11 PARAM-
ETER EDITING" on page 19.
11. LOW and HIGH adjusts the amount of low-end and high-end frequency content.
12. <FILTER TYPE> LEDs that indicate the current type of filter and also if the filter is on or not.
13. RESONANCE sets the resonance of the filter.
14. [FILTER TYPE] selects between the different filter types. Also, pressing both keys at the same time
toggles the filter on and off.
15. FREQUENCY sets the filter's cutoff frequency.
16. DRY/WET sets the balance between the unprocessed (dry) signal and the processed (wet) signal.
17. WET LEVEL sets the level of the processed (wet) signal.
18. DRIVE controls the amount of drive. This will increase the effect of the selected circuit type,
typically resulting in more distortion.
19. CIRCUIT SELECTOR chooses between the eight different types of effect circuits.
20. [SETTINGS] key accesses the SETTINGS menu. Both preset-specific settings and global settings
are found in this menu.
21. [ACTIVE] toggles the effect between active and bypassed.
11
Advertisement
Table of Contents
