Toyota 2016 Yaris Owner's Manual page 523

1
Remove the battery cover.
2
Make sure the booster battery is 12 V and that its negative terminal
is grounded.
3
If the booster battery is in another vehicle, do not allow both vehi-
cles to touch. Turn off the engine of the vehicle with the booster bat-
tery and all unnecessary electrical loads in both vehicles.
4
Connect the jumper cables in the exact sequence as in the illustra-
tion.
• Connect one end of a cable to the positive terminal on the dis-
charged battery (1).
• Attach the other end to the positive terminal on the booster battery
(2).
• Connect one end of the other cable to the negative terminal of the
booster battery (3).
• Connect the other end to the ground point indicated in the illustra-
tion away from the discharged battery (4).
5
Start the engine of the booster vehicle and run it a few minutes.
Then start the engine of the other vehicle.
6
When finished, carefully disconnect the cables in the reverse order
described in the illustration.
7
If the battery cover has been removed, install it in the reverse order
of removal.
Verify that the covers are securely installed.
YARIS_SEDAN_OM_OM99M18z_(U)
6-3. Battery Runs Out
523
6