C Safety & Warnings - Projectiondesign EVO2SX+ User Manual

C
SAFETY & WARNINGS
This user guide contains important information about safety precautions and the set-
up and use of the projector. Please read the manual carefully before you operate the
projector.
SAFETY
This device complies with relevant safety regulations for data processing equipment
for use in an office environment. Before using the projector for the first time, please
read the safety instructions thoroughly.
WARNING
Use only the cables and cords supplied with the projector or original replacement
cables. Using other cables or cords may lead to malfunction and permanent damage
of the unit.
Always use 3-prong / grounded power cord to ensure proper grounding of the unit.
Never use 2-prong power cords, as this is dangerous and could lead to electrical
shock.
Never open the unit. The projector contains no user serviceable parts. Refer all
repairs to qualified personnel only. Make sure that no objects enter into the vents and
openings of the set.
Do not spill any liquids on the projector or into the vents or openings of the unit.
Always remove lens cap before switching on the projector. If the lens cap is not
removed, it may melt due to the high energy light emitted through the lens. Melting the
lens cap may permanently damage the surface of the projection lens.
Do not look into the projection lens when the projector is switched on. The strong light
may permanently damage sight. Do not look into the laser beam when activated on
the remote control. Laser light may permanently damage sight.
Do not point laser beam on people.
Only place the projector on a stable surface, or mount it securely using an approved
ceiling-mount.
Do not drop the projector.
Always operate the projector horizontally, within the range of the adjustable rear feet.
Operating the unit in other positions may reduce lamp life significantly, and may lead
to overheating, resulting in malfunctioning.
Always allow ample airflow through the projector. Never block any of the air vents.
Never cover the unit in any way while running. Allow for sufficient distance to walls and
ceilings to avoid overheating.
Minimum safety distance to any side of the unit is 50 cm / 20" in any direction.
CAUTION! Hot air is exhausted from the rear vent. Do not place objects that are
sensitive to heat nearer than 0cm / 20" to the exhaust vent.
The projector is designed for indoor use only. Never operate the unit outdoors.