G Indicator - Projectiondesign EVO2SX+ User Manual

G
INDICATORS
INDICATOR
The light next to the power key indicates the overall system status by blue, orange and
red colors.
PERMANENT BLUE LIGHT
The projector is turned on and in normal operation.
PERMANENT ORANGE LIGHT
The unit is in standby mode; no source(s) connected, or the source(s) connected are
inactive or switched off, thereby activating the powersave function (DPMS). You may
enable or disable the power save function in the SET UP sub menu, DPMS on or off.
FLASHING ORANGE LIGHT
Please wait. The yellow light will flash a period after power cord is connected (10-
15 sec.), and a period after going to standby mode while lamp is cooling down
(approximately 45 sec.). The projector may not be turned on again until the light has
POWER
turned to permanent yellow.
FLASHING RED LIGHT
STATUS
Projector is overheated. Turn off immediately! Check if air inlets are covered or if ambient
POWER
temperature is outside specifications. The projector can not be restarted unless the
power cord is disconnected and reconnected again. If the projector continues to flash
red, you will need to return the unit for service.
STATUS
PERMANENT RED LIGHT
Lamp life has expired. Please change projection lamp immediately. Failing to change
lamp may lead to lamp explosion.
NO LIGHT
Power is not connected to the projector.
12