Safety & Warnings - Projectiondesign cineo3+ 1080 User Manual

SAFETY & WARNINGS
This user guide contains important information about safety precautions and the set-up and use of
the projector. Please read the manual carefully before you operate the projector.
SAFETY
This device complies with relevant safety regulations for data processing equipment for use in an
office environment. Before using the projector for the first time, please read the safety instructions
thoroughly.
WARNING
Use only the cables and cords supplied with the projector or original replacement cables. Using
other cables or cords may lead to malfunction and permanent damage of the unit.
Always use 3-prong / grounded power cord to ensure proper grounding of the unit. Never use 2-
prong power cords, as this is dangerous and could lead to electrical shock.
Never open the unit. The projector contains no user serviceable parts. Refer all repairs to qualified
personnel only.
Make sure that no objects enter into the vents and openings of the set. Do not spill any liquids on
the projector or into the vents or openings of the unit.
Always remove lens cap before switching on the projector. If the lens cap is not removed, it may
melt due to the high energy light emitted through the lens. Melting the lens cap may permanently
damage the surface of the projection lens.
Do not look into the projection lens when the projector is switched on. The strong light may
permanently damage sight.
Do not look into the laser beam when activated on the remote control. Laser light may permanently
damage sight. Do not point laser beam on people.
Only place the projector on a stable surface, or mount it securely using an approved ceiling-
mount.
Do not drop the projector.
Always operate the projector horizontally, within the range of the adjustable rear feet. Operating
the unit in other positions may reduce lamp life significantly, and may lead to overheating, resulting
in malfunctioning.
Always allow ample airflow through the projector. Never block any of the air vents. Never cover the
unit in any way while running. Allow for sufficient distance to walls and ceilings to avoid overheating.
Minimum safety distance to any side of the unit is 50 cm / 20" in any direction.
CAUTION! Hot air is exhausted from the rear vent. Do not place objects that are sensitive to heat
nearer than 50cm / 20" to the exhaust vent.
The projector is designed for indoor use only. Never operate the unit outdoors.
4