Olympus BX45 Instructions Manual page 33

8-2 Detailed Assembly Procedures
³
Fig. 38
|
ƒ
...
†
Fig. 39
1
Installing the Bulb
Use only the designated bulb 6V30WHAL (PHILIPS 5761).
@
1. Holding the bulb @ with gloves or a piece of gauze, insert the bulb pins
² straight and fully into the pin holes ³ on the lamp socket.
# To prevent reduced bulb life or cracking, do not touch the bulb with
²
bare hands. If fingerprints are accidentally left on the bulb, wipe the
bulb with a soft cloth.
2. Aligning the guide pins | with the guide pin holes ƒ at the rear of the
microscope frame, and the plug ... with the socket †, gently push the
lamp socket all the way into place.
Caution for Bulb Replacement During Use or Right After Use
The bulb and the lamp socket are areas near these will be extremely hot
during and right after use.
Set the main switch to "
wall outlet, then allow the old bulb and lamp socket to cool before re-
placing the bulb with a new of the designated type.
5 Attaching the Objectives
Screw in the objectives into the holes of revolving nosepiece by begin-
ning with the lowest-power objective toward higher-power objectives.
}If you want to observe images of 10X and 40X objectives alternately,
attach them side by side.
(Figs. 38 & 39)
" (OFF), disconnect the power cord from the
BX45
29