14
Installing ACP IV
Installing ACP IV and connecting cables
After setting PI485, the ACP IV shall be installed in an adequate place, and RS-485 cable shall be
connected for the communication with PI485.
And, Ethernet cable (LAN cable) shall be connected for the connection with internet or AC Manager
IV.
To fix the ACP IV, the following 2 methods may be used.
Install in DIN RAIL or fix to the wall considering the environment of the site.
Power
CAUTION
If four times the power connector for the connection, as shown by using the right connection, but
please note that an electric shock.
Use the designated parts must be connected to a power source.
Connector manufacturers: PHOENIX CONTACT
y
PartNo: MVSTBR 2,5 / 2-ST-5, 08 2P 5.00 mm
PACP4B000
LAN cable
RS-485 cable
Need help?
Do you have a question about the PACP4B000 and is the answer not in the manual?