Installing Acp Iv And Connect- Ing Cables - LG ACP IV Install/Owner’s Manual

Installing ACP IV and connect-
ing cables
After setting PI485, the ACP IV shall be
installed in an adequate place, and RS-485
cable shall be connected for the communica-
tion with PI485.
And, Ethernet cable (LAN cable) shall be con-
nected for the connection with internet or AC
Manager IV.
To fix the ACP IV, the following 2 methods
may be used.
Install in DIN RAIL or fix to the wall consider-
ing the environment of the site.
Power
LAN cable
CAUTION
!
If four times the power con-
nector for the connection, as
shown by using the right
connection, but please note
that an electric shock.
Use the designated parts
must be connected to a
power source.
• Connector manufacturers: PHOENIX
CONTACTPartNo: MVSTBR 2,5 / 2-ST-5,
08 2P 5.00 mm
PACP4B000
RS-485 cable
INSTALLING ACP IV
Installing the ACP IV in DIN RAIL
ACP IV can be installed in DIN RAIL with
width 35 mm and height 7.5 mm.
Proceed as the follows to install the ACP IV in
an adequate place.
The installation method of the ACP IV is
explained here with the example of installing
the ACP IV in DIN RAIL.
• Decide the space to install the ACP IV.
• Before installing the ACP IV, check if it is the
adequate place to connect the ACP IV with
the power, RS-485, and LAN cable.
• Install DIN RAIL.
• Hook the top part of the ACP IV on DIN
RAIL.
• Push the main body of the ACP IV until you
hear the sound of installation.
• Pull the ACP IV to check if it is fixed.
! CAUTION
• After installing to DIN RAIL, do not fix to
the wall using screws.
• ACP IV may be damaged.
• DIN Rail fixing Screw Spec: M3, screw
head height 2.0 ~ 1.75 mm, screw head
diameter 7.0 ~ 5.5 mm
11
Hooking on
DIN RAIL
Fixing to DIN RAIL