What To Do If - Siemens txl 720k Instruction Manual And Installation Instructions

What to do if ...

What to do if ...
The Start/Stop" indicator p
lamp does not come on. l d
The dryer does not start.
The Clean the fluff filter"
indicator lamp is flashing. i di l i fl hi
d
Danger, electrical current.
Repairs must only be carried out by the after sales
service or an authorised expert.
If you cannot rectify a fault yourself, or a repair is
necessary:
q Turn the programme selector to Off.
q Remove the plug from the socket.
q Contact the after sales service (see page 38).
Cause
The dryer is not plugged in.
The Start/Stop button has not been
pressed.
A fuse has blown in your home.
The Start/Stop button has not been
pressed.
The door and/or maintenance flap
are not closed properly.
No programme has been set.
The ambient temperature is below
5 ºC.
The filter is blocked.
The condenser unit is clogged.
Solution
Plug in the dryer.
Press the button.
Reset/change the fuse.
Press the button.
Close the maintenance flap and the
door.
Select the programme you require
using the programme selector.
Increase the room temperature.
Clean the filter (see page 30).
Clean the condenser unit
(see page 32).
Check the installation conditions
(see page 40).
35