Electrical
connection
Scope of delivery
Accessories
Caution:
The dryer must be connected correctly to an A.C.
contactor socket.
The mains voltage must comply with the voltage
information given on the identification plate (on the
rear of the unit).
The connected load and the necessary fusing are
shown on the identification plate.
The dryer can be modified to suit the existing fusing
(see page 48).
Ensure that:
- the plug and the socket are compatible.
- the wire cross section is sufficient.
- the earth system is installed in accordance with
regulations.
If the mains cable needs altering, this should only be
done by the after sales service.
Do not use multiple plugs/connectors and/or
extension cables.
Only use current operated circuit breakers which are
marked as follows: 7.
Do not touch the plug with wet hands.
Always pull the plug grip to remove the plug from the
socket.
The dryer is delivered as a complete unit. The instruc
tion manual and any special equipment ordered can
be found in the drum.
If you require, the dryer can be adapted or added to
on using separately available kits (see page 42 on
wards).
41