The tool should be connected only to a power supply of Uncertainty (K) : 1.5 m/s the same voltage as indicated on the nameplate, and can Model HM1317C only be operated on single-phase AC supply. They are double-insulated and can, therefore, also be used from Work mode : chiseling function with side handle sockets without earth wire.
Do not expose power tools to rain or wet Identification number 0197 conditions. Water entering a power tool will Model HM1307C,HM1317C increase the risk of electric shock. Measured Sound Power Level: 101dB (A) Do not abuse the cord. Never use the cord for Guaranteed Sound Power Level: 103dB (A) carrying, pulling or unplugging the power tool.
Page 4
When operating a power tool outdoors, use an 20. Disconnect the plug from the power source extension cord suitable for outdoor use. Use of and/or the battery pack from the power tool a cord suitable for outdoor use reduces the risk of before making any adjustments, changing electric shock.
Be sure the bit is secured in place before FUNCTIONAL DESCRIPTION operation. Under normal operation, the tool is designed to produce vibration. The screws can come CAUTION: loose easily, causing a breakdown or accident. Always be sure that the tool is switched off and •...
Page 6
For model HM1317C,HM1317CB only The side handle can be swung 360° on the vertical and secured at any desired position. Just loosen the clamp NOTE: nut to swing the side handle to a desired position. Then Blows at no load per minute becomes smaller than •...
To install the bit, follow either procedure (1) or (2) OPERATION described below. Pivot the tool retainer back and slightly downward. Chipping/Scaling/Demolition Insert the bit into the tool holder as far as it will go. To securely retain the bit, return the tool retainer to its original position.
Page 8
To reassemble the tool, follow the disassembling performed by Makita Authorized Service Centers, always procedure in reverse. using Makita replacement parts. For model HM1317C,HM1317CB only ACCESSORIES 1. Rear cover 2. Hex wrench CAUTION:...
Page 12
Makita Corporation Anjo, Aichi, Japan www.makita.com 884923C224...