Lutron Electronics HT-305 Operation Manual page 10

5-1 Change the Temp
Use the " Set Button " ( 3-11, Fig. 1 ) to select the main
function to "
℉
Function Button " ( 3-5, Fig. 1 ) a while will determine
the default Temp. unit to
@ Press the " Function Button ", if the upper display value
show " 0 ", the default Temp. unit is ℃
@ Press the " Function Button ", if the upper display value
show " 1 ", the default Temp. unit is
After the function is determined, press the " Enter Button "
( 3-4, Fig. 1 ) to confirm and save the selection data into
memory IC permanently. Press the " Esc Button " ( 3-3.
Fig. 1 ) will revert to normal display screen.
5-2 Auto power ON/OFF
Use the " Set Button " ( 3-11, Fig. 1 ) to select the main
function to " OFF ", then one by one to press the "
Function Button " ( 3-5, Fig. 1 ) a while will determine
the default the power management system is Auto
Power Off enable or disable.
@ Press the " Function Button " once, if the upper display
value show " 0 ", it is not Auto Power Off management
( disable ).
@ Press the " Function Button " once, if the upper display
value show " 1 ", it is the Auto Power Off management
( enable ).
,
℃ ℉
", then one by one to press the "
or
℃
8
unit
℉
.
℉