THORLABS LDC200C series Operation Manual page 8

LDC200C Series
Do not obstruct the air ventilation slots in housing!
Do not remove covers!
Refer servicing to qualified personnel!
Warning
Laser modules can deliver up to several 100mW of maybe even invisible laser radiation! When
operated incorrectly, this can cause severe damage to your eyes and health! Be sure to pay
strict attention to the safety recommendations of the appropriate laser safety class, as stated
for the used laser diode.
Attention
Use only duly shielded connection cables for laser, photodiode and control input/output
connections.
Mobile telephones, cellular phones or other radio transmitters must not be used within the
range of three meters of this unit since the electromagnetic field intensity may then exceed the
maximum allowed disturbance values according to IEC61326-1.
This product has been tested and found complying with the limits according to IEC 61326-1 for
using connection cables shorter than or equal to 3 meters (9.8 feet).
Attention
The following statement applies to the products covered in this manual, unless otherwise
specified herein. The statement for other products will appear in the accompanying
documentation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules and meets all requirements of the Canadian
Interference-Causing Equipment Standard ICES-003 for digital apparatus. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
· Consult the dealer or an experienced radio/T.V. technician for help.
Thorlabs GmbH is not responsible for any radio television interference caused by modifications
of this equipment or the substitution or attachment of connecting cables and equipment other
than those specified by Thorlabs GmbH. The correction of interference caused by such
unauthorized modification, substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all
optional peripheral or host devices. Failure to do so may violate FCC and ICES rules.
6 © 2015 Thorlabs