Drum Edit - Technics SX-KN7000 Operating Instructions Manual

Part IV
CYCLE PLAY
You can aurally check the data you are editing
by accessing the CYCLE PLAY display from the
NOTE EDIT display.
• If you wish other tracks to be played back,
they should be selected beforehand on the
SEQUENCER PLAY display. (Refer to page
83.)
1.
On the NOTE EDIT display, press the PLAY
button.
• The display looks similar to the following.
2.
Use the START MEASURE
to select the beginning playback measure.
3.
Use the END MEASURE
select the last playback measure.

Drum Edit

The DRUMS part can be edited on a specialized display. This differs from the normal STEP RECORD
edit procedure, and is a convenient way to check the data for each note.
1.
On the SEQ MENU display, select RECORD
& EDIT.
2.
On the RECORD & EDIT display, select DRUM
EDIT.
3.
On the PART SELECT display, select the track
for the DRUMS part.
• The CHORD, RHYTHM and CONTROL tracks
cannot be selected.
• The display looks similar to the following.
∧ ∨
and buttons
∧ ∨
and buttons to
4.
Press the START/STOP button.
• Cycle playback of the specified measures
begins.
• If the SOLO button is turned on, playback
changes to that of the recording track only. If
it is turned off, all the tracks specified on the
SEQUENCER PLAY display are played back.
5.
To stop cycle playback, press the START/
STOP button again.
• During playback stop, if the SEQUENCER
RESET (FILL IN 1) button is pressed, the
SEQUENCER returns to the measure number
specified in step 2. If the SEQUENCER
RESET button is
SEQUENCER returns to measure 1.
Use the SOUND L and M buttons to select
4.
the percussion instrument you wish to edit.
• The number to the left of the instrument name
is its MIDI NOTE NUMBER in the Technics
arrangement.
• If sounds other than percussion instrument
sounds are assigned, they are not displayed.
Use the MEAS L and M buttons to select the
5.
measure you wish to edit.
6.
Use the CURSOR
move the cursor (M) to the point you wish to
edit.
• Recorded performance data is shown as ver-
tical bars. Data selected for editing is
highlighted.
• You can use the INC
change the increment of cursor movement.
The resolution can be set at
if NOTE data is present between increments,
the cursor will stop.
∧ ∨
• Use the POS
and
value.
Sequencer
pressed again, the
and buttons to
∧ ∨
and buttons to
/96. However,
buttons to change the
99
QQTG0671